If they do not, mark the locations where the pilot holes need to be. Place the chartplotter in the hole, and make sure that the mounting holes on the chartplotter line up with the pilot holes on the flush-mount template after cutting, sanding, and filing the hole. Lock washers ×4 Chartplotter Flat washers ×4 Mounting studs ×4 Rubber gasket Hex nuts ×4 Mounting surface Flush Mounting a GPSMAP 4008/4208/4012/4212/5008/5208/5012/5212 Chartplotter Flush Mounting a GPSMAP 4010/4210 Chartplotter or a GPSMAP 5015/5215 Chartplotter: Hardware (included): t ools required (not included): Flush Mounting a GPSMAP 4008/4208/4012/4212 Chartplotter or a GPSMAP 5008/5208/5012/5212 Chartplotter Hardware (included): t ools required (not included): Be sure to follow the instructions for your chartplotter model.
#Simrad chartplotter nmea 2000 network not available series#
Bail Mounting the GPSMAP 4000/5000 Series Chartplotter Use the included brackeįlush Mounting the GPSMAP 4000/5000 Series Chartplotter The flush-mount method you will use with your chartplotter is dependent on the model. Because of the larger size, you must flush mount the GPSMAP 5015/5215 chartplotters. notice You cannot bail mount the GPSMAP 5015/5215 chartplotters. You can use the included bracket to bail mount the chartplotter, or you can use the included template and hardware to flush mount the chartplotter. Mounting the GPSMAP 4000/5000 Series Chartplotter You can mount the GPSMAP 4000/5000 series chartplotters one of two ways. notice When drilling or cutting, always check what is on the opposite side of the surfa CAutIon Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding. These items are available at most marine dealers.
You need the appropriate fasteners, tools, and mounts listed in each section. ® GPSMAP 4000/5000 Series Installation Instructions The GPSMAP 4000/5000 series chartplotter and GPS antenna must be properly installed according to the following instructions.